80W Power Supply - 24-48 Vdc Input PX3511 1. Product Description
+15 Vdc: maximum of 200 mVpp -15 Vdc: maximum of 200 mVpp
The PX3511 is a switched power supply, 19.2 to 57.6 Vdc
input, double-height euro standard, and supplies power for
2. Components
The package contains the following items:
Maximum output power according to ambient temperature:
QK2691:1/2 AA Lithium battery – module for memory
retention in CPUs connected at the same rack as the power supply. It is installed on the front panel of the power supply, and is hot-swappable.
3. Functional Features 3.1. General Features Connected to the process by screw terminals. Cables with gauges between 0.5 and 1.5 mm2 LEDs that indicate the status of the output voltages. Normally open dry contact indicating operation of the
power source, available at the OK0, OK1 and the GND
Battery self-test circuit. The status is shown in a LED on
the panel, and may be read by the CPU diagnostic
Reading of the power supply statu (+5, +15 and – 15V) by
Protection class: IP20, protection from incidental access
charge duration (self-discharging): 5 years @ 25°C
Operation with maximum output load up to 10 ms of
according to IEC Pub. 144 (1963) standard
interruption in power supply without affecting operation
according to IEC 1131/IEC 255-11 standards
Protections: any of these failures causes the source to turn
off, with automatic reactivation after repair:
Relative humidity: 5 to 95% non-condensing
according to IEC 1131 standard, level RH2
according to the IEC 1131 and IEC-536-1976
calculated according to MIL HBDF 217E standard
1500 Vac rms between inputs and outputs during 1 minute
3.2. Electrical Features
according to the IEC 1131 e IEC 255-5 standards
1000 Vac rms between the dry contacts which
Severity level of the electrostatic discharge: 4
according to the IEC-1131 standard of severity level
A and IEEE 3790.1 part AC (SWC)/IEC 255-22-1
Immunity to electric noise of the fast transient type:
according to the IEC 801-4 standard, level IV
Immunity to the radiated electromagnetic field:
according to the IEC-1131/IEC 801-3 standard
Resistive switching capacity of operation indication contact
1 A @ 30 Vdc 0,28 A @ 110 Vdc 1 A @ 62,5 Vac 0,5 A @ 125 Vac
80W Power Supply - 24-48 Vdc Input PX3511 4. Physical Dimensions 5. Purchase Information 5.1. Optional Items The following item can be purchased separately:
The QK2691provides energy for RAM memory retention in the CPUs connected to the power source rack; it consists of a non-rechargeable lithium battery.
6. Installation The PX3511 source must be connected to the rack bus with the power supply off. The power is supplied from the front connector, using cables from 0.5 to 1.5 mm2
The ground wire connection must be carefully carried out. A wire with a minimum 1.5 mm2 gauge must be connected to the system common ground.
For further information refer to the PX2004 CPU User’s Guides.
The Journal of Specialised Translation The ethical dimension of translation revision. An empirical study. Alexander Künzli, Stockholm University, Department of French, Italian and Classical Languages, Sweden ABSTRACT This paper investigates translation revision using think-aloud protocols. Ten professional translators were asked to think aloud while revising three draft transl
Aetna considers the following injections or procedures medically necessary for the treatment of back pain; provided, however, that only 1 invasive modality or procedure will be considered medically necessary at a time. Epidural injections of corticosteroid preparations (e.g., Depo-Medrol), with or without added anesthetic agents, are considered medically necessary in the outpatient setting